Finishing Component Replacement; Replacing The System Cover - Sun Microsystems Sun Blade 100 Service Manual

9
C H A P T E R

Finishing Component Replacement

This chapter describes the activities you must complete after you finish removing
and replacing internal system components. This chapter also explains how to
externally control standby operation.
This chapter contains the following topics:
Section 9.1 "Replacing the System Cover" on page 9-1
Section 9.2 "Powering On the System" on page 9-2
9.1

Replacing the System Cover

1. Remove the wrist strap from the system chassis and from your wrist.
2. Position the system cover onto the system chassis. Slide the system cover toward
the front of the system until the cover tabs lock (
3. Using a No. 2 Phillips screwdriver, replace the two screws securing the system
cover to the chassis.
).
FIGURE 9-1
9-1