Bypassing Post; Resetting Variables To Default Settings; Initializing Motherboard Post - Sun Microsystems Sun Blade 100 Service Manual

CODE EXAMPLE 3-3
Ethernet address 8:0:20:cf:46:11, Host ID: 61067537.
Power On Self Test Failed.
ok
3.6

Bypassing POST

To bypass POST:
At the system prompt, type:
ok% setenv diag-level? off
ok% setenv diag-switch? false
3.7

Resetting Variables to Default Settings

To set the system NVRAM parameters to the original default settings:
At the system prompt, type:
ok% set-defaults
3.8

Initializing Motherboard POST

To initialize the motherboard POST:
1. Power off the system.
2. Before replacing the motherboard, remove any optional components, such as PCI
cards, then repeat the POST.
Typical Error Code Failure Message
Cause: DIMM2
Chapter 3 Power-On Self-Test 3-15