Reference Information; Ide Cabling Configuration; Jumper Settings; Figure A-1 Ide Cabling Configuration - Sun Microsystems Sun Blade 100 Service Manual

A.4

Reference Information

This section contains the following reference information:
Section A.4.1 "IDE Cabling Configuration" on page A-3
Section A.4.2 "Jumper Settings" on page A-3
Section A.4.3 "CD Handling and Use" on page A-4
A.4.1

IDE Cabling Configuration

FIGURE A-1
optional secondary hard drive. An optional cable with two connectors is shipped
with the secondary drive and is connected as shown in
Riser board (J504)
FIGURE A-1
A.4.2

Jumper Settings

Before you install a CD-ROM or DVD-ROM drive or a hard drive in a Sun Blade 100
system, verify that the drive's back panel mode-select jumper is set as follows:
Set the CD-ROM drive jumper (located on the CD-ROM drive back panel) to either
"CS," "Enable Cable Select," or "Cable Select."
shows the IDE cabling. The Sun Blade 100 system can support an
Riser board (J503)
IDE 2
IDE 1
IDE Cabling Configuration
Appendix A
Optional second hard drive
(Secondary HDD)
CD-ROM or DVD-ROM drive
(CD/DVD)
Product Specifications and Reference Information
FIGURE A-1.
Primary hard drive
(Primary HDD)
A-3