Operation
Available Parameter Settings
( (
78
Operating Instructions Combics Indicators
Example: Enter 100 g as the upper limit of Class 1. Then enter 15%. When working
with 3 classes, this yields the following weight classes:
Class 0: up to the minimum load
Class 1: > minimum load - 100 g
Class 2: > 100 g – 115 g
Class 3: > 115 g - maximum load
When working with 5 classes, this yields the following weight classes:
Class 0: up to the minimum load
Class 1: > minimum load - 100 g
Class 2: > 100 g – 115 g
Class 3: > 115 g – 130 g
Class 4: > 130 g – 145 g
Class 5: > 145 g - maximum load
The values entered remain valid until deleted by pressing the c key or until
overwritten by a new value. They remain saved after the scale is switch-off.
Preparation
Open the APPLIC. / APPLIC.2 / CLASS. menu.
t
* = Factory setting
MIN.INIT Minimum load for initialization
CTRL.SET Activate SET control output
OUTP.ACT Activation of outputs
QTY. Number of classes
INPUT Parameter input
PRINT Automatic printing
)
To save the setting, press the ) key.
t
To exit setup: Press the ( key several times.
...
t
1 digit
1 digit
2 digits
2 digit
5 digits
5 digit
10 digits
10 digT.
20 digits
20 digT.
50 digits
50 digT.
100 digits
100 diG.
200 digits
200 diG.
500 digits
500 diG.
1000 digits
1000 dI.
SET output
OUTPUT
Ready to operate
OP.READY
Off
OFF
Always on
ALWAY.ON
On at stability
STABIL.
3 classes
3 CLASS
5 classes
5 CLASS
Weight values
WEIGHTS
Percentage values
PERC.TAG
4.10.
Off
manual
On
automat
3.6
3.6.1*
3.6.2
3.6.3
3.6.4
3.6.5
3.6.6
3.6.7
3.6.8
3.6.9
3.6.10
4.3.
4.3.1*
4.3.2
4.7
4.7.1*
4.7.2
4.7.3
4.8.
4.8.1*
4.8.2
4.9.
4.9.1*
4.9.2
4.10.1*
4.10.2