Operation
56
Operating Instructions Combics Indicators
Neutral Measurement
With this application you can measure the length, surface and volume of parts that
have roughly the same specific weight. The o symbol is displayed as the unit (menu
APPLIC.1).
Features
–
Save the reference weight "wRef" from the weighing platform:
–
Enter the reference weight "wRef" through the keypad
–
Enter the factor for calculation "nRef" using the keypad
–
Enter reference sample weight using a barcode scanner
–
Measuring with two weighing platforms
Activate Info mode with the I key
–
Toggle the display between measurement and weight via the w key
–
–
The level of accuracy (display resolution) can be set when the calculated
reference weight is applied
–
Automatic taring of container weight
Setting: Applic. / aut.tare, menu item 3.7
–
Automatic initialization when the scale is switched on. The indicator is
initialized with the most recently used values for reference sample quantity
"nRef" and reference sample weight "wRef."
Setting: Applic. / aut.strt, menu item 3.8
Exit application, delete parameters
The value of the reference sample weight in the reference memory remains active
until it is deleted via the c key or overwritten or until the application is changed.
The reference sample weight also remains saved after the scale is turned off.
You can assign different functions to the c key for deleting applications. When
you clear applications, you can delete either the data stored for all applications or
just selected data stored for the active application.
Setting: Applic./CLER.CF menu item 3.24
Tare function:
If you store a tare (weight value) by pressing the ) key, you can later enter a tare
value manually. The tare value you enter is added to the stored tare value.
Setting: Applic. / TARE.FNC menu item 3.25.1 (factory setting)
A tare value entered manually overwrites a stored tare value (weight value). If you
enter a tare value manually, a tare value (weight value) stored later overwrites the
manually entered value.
Setting: Applic. / TARE.FNC menu item 3.25.2
Restore factory default settings: Applic./Reset menu item 9.1.
Reference weight
In order to calculate the length, surface or volume of a given sample, the average
weight of a reference quantity of the sample must be known (in the example below,
the reference is 1 meter of electrical cable). There are different ways to enter the
reference weight:
Calculating the reference weight
–
Place the reference quantity (defined by the calculation factor) on the connected
weighing platform and calculate the reference sample weight by pressing the
O key.
or
–
Place any amount of the sample material on the connected weighing platform,
enter the calculation factor through the keypad, and press the r key to
calculated reference sample weight.
(Combics 2)
Z nM