Competence series; gem plus series; cp series; gc series; gp series; electronic semimicro- and analytical precision balances and precious metal scales (88 pages)
Contents Contents Explanation of the Symbols Safety Instructions Warranty Setting Up the Scale Installation Care and Maintenance Declarations of Conformity Accessories The following symbols are used in these instructions: § indicates steps you must perform $ indicates steps you must perform only under certain conditions >...
Installation § Connect the cable of the weighing platform to the indicator. Note: The cable gland along with the screw fasteners is already pre-assembled. Use extreme care when attaching or detaching a cable. § Strip off the insulation at the cable end and attach the cable as follows: –...
Page 7
Color Codes of the Wiring for Weighing Platforms, Models CAPS..-LU Platform size Wiring Diagram for the Indicator in inch No.: 1 12.6 x 9.5 Blue Green White Gray Black 15.8 x 11.8 Blue Green White Gray Black 19.7 x 15.8 Blue Green White...
Page 8
Resolutions: Resolutions: Resolutions: Resolutions: Resolutions: Readability HR configurable up to 5,000e up to 30.000 d Weighing capacity NTEP non commercial in lbs in lbs in lbs 0.002 0.005 0.01 0.02 0.05 0.05 1000 2500 5000 Operating Limits You should not place loads on the scale that exceed its maximum weighing capacity. Depending on the position of the load (center, side, one-sided corner load), the maximum capacity of the weighing platform is in lbs as follows: Model*...
Care and Maintenance Care and Maintenance Sartorius products are packaged to ensure safe shipment Cleaning using environmentally friendly materials.If after successful $ Unplug the scale from the AC power before cleaning. installation of the equipment,you will not need the $ To clean the weighing platform in a dry area: use a piece of cloth packaging,you should return it for recycling because it is a wet with a commercially available cleaning agent to wipe it down.
The operator shall be responsible for any modifications to Sartorius equipment and for any connections of cables or equipment not supplied by Sartorius and must check and, if necessary, correct these modifications and connections. On request, Sartorius will provide information on the minimum operating specifications (in accordance with the Standards listed above for defined immunity to interference).
Accessories Drive-on ramp, painted, for platform sizes: Drive-on ramp, AISI 316 Ti stainless steel (tread plate) Platform for platform sizes: sizes: in inch Accessory no. latform sizes: in inch Accessory no. 30 x 24 YAR-CWP-24 30 x 24 YAR-CWSST-24 30 x 24 YAR-CWP-30 30 x 24 YAR-CWSST-30...
Page 12
Column, painted, for attaching indicator to platform, for sizes: Size in inch Accessory no. DC (12.6 x 9.5), height 13 YDH01CWP ED (15.8 x 11.8), height 19.7 and YDH02CWP FE (19.7 x 15.8), height 19.7 YDH02CWP FE (19.7 x 15.8), height 29.5 YDH03CWP Column, stainless steel, for attaching indicator to platform, for sizes:...
Page 13
Sartorius AG Weender Landstrasse 94 –108 37075 Goettingen,Germany Phone +49.551.308.0 Fax +49.551.308.3289 www.sartorius.com Copyright by Sartorius AG, Goettingen,Germany. All rights reserved.No part of this publication may be reprinted or translated in any form or by any means without the prior written permission of Sartorius AG.