Set End Pressure Alarm - Aeris Epic Operating Manual

SET END PRESSURE ALARM

> Graphic ND
> Set Point numeric value, flashing.
> Symbol PSI (or M)
 Pressing and releasing the S button momentarily (< 2
seconds) will increase the Set Point from 300 to 1500 PSI
(20 to 105 BAR) in 100 PSI (5 BAR) increments.
 Depressing and holding the S button will scroll through the
Set Points at a rate of 4 Set Points per second until it is
released.
 Pressing and releasing the A button momentarily (< 2
seconds) will save the setting and/or advance to the S T
PO2 ALARM screen with the Set Point flashing.
 Pressing and releasing the A button momentarily and
repeatedly (< 2 seconds each time) will step through the
other S T A screens.
 Depressing the A and S buttons simultaneously for 2
seconds will save the setting and revert back to the S T A
screen.
 Depressing and holding the M button for 2 seconds or if no
button is pressed for a period of 2 minutes operation will
revert to the NORM or GAUG SURF MAIN screen.
information includes (Fig. 54):
The ND Pressure
Alarm will activate
when Pressure in the
Tank being used at
the time (TMT 1, 2 ,
or 3) decreases to the
Alarm Set Point.
61