Installing A Transmitter On A Regulator; Transmitter Compatibility With Nitrox - Aeris Epic Operating Manual

164

INSTALLING A TRANSMITTER ON A REGULATOR

To install the Transmitter on the Regulator First Stage:
 Remove the existing Pressure Gauge and High Pressure
Hose, or the High Pressure Port Plug from the Port marked
HP using the proper size Hex Key.
 Lightly lubricate the O-ring and Threads of the Transmitter
fitting with a halocarbon based lubricant such as Christo-
Lube MCG111 (provided in A RIS Battery Kits).
 Thread the Transmitter clockwise by hand into the
Regulator's HP Port (Fig. 155) and tighten until secure with
a 5/8" open-end wrench.
 Attach the Regulator First Stage to a full Scuba Tank and
pressurize by slowly opening the Tank Valve, listening for
any indication of air leaking around the Fitting.
 If air leakage is present, DO NOT use, take the complete
Regulator Assembly to an Authorized A RIS dealer for
inspection and service.

TRANSMITTER COMPATIBILITY WITH NITROX

When packaged and shipped from the factory, A RIS PIC
Transmitters are rated for use with compressed Air and/or
nitrogen-oxygen (Nitrox) breathing gas mixtures containing up to
99% O2 by volume and with 100% O2.