Aeris Epic Operating Manual page 121

Due to the possibility that sufficient air may not be available in
the Switch From tank to complete the dive, the Switch to the
prohibitive Mix can still be made. If the Switch is made to the
prohibitive Mix while in NORM NO D CO DIV Mode, the
High PO2 Alarm will activate. If the Switch is made to the
prohibitive Mix while in D CO DIV Mode, the message HIGH
> PO2 will replace the scrolling D CO message until the High
PO2 condition clears.
Switching of Gas Mixes can only to be performed during the
time that a Gas Switch Preview screen is being displayed. These
are accessed from a NORM DIV MAIN screen.
 Pressing and holding the M button for 2 seconds while
viewing a NORM DIV MAIN screen will access the TMT
2-3 US screen displaying the Set Point S LF (Fig. 107). If
BUD is displayed, indicating that the PIC is set for
Checking Buddy Pressure, a Gas Switch cannot be made.
 Pressing and releasing the M button momentarily (< 2
seconds) while the TMT 2-3 US screen is displayed (with
the setting S LF) will access the GAS 1 Switch Preview
Display.
 The PIC will revert to the NORM DIV MAIN screen after
10 seconds of no further M button action.
When a switch is
made to another
GAS, there may be
a delay of 5 to 15
seconds before the
PIC's Receiver
picks up the TMT's
signal.
1 1