Aeris Epic Operating Manual page 70

TMT 1 is the Default
Transmitter while on
the Surface, prior to
a dive and 10
minutes after a dive.
70
SET TMT 1
information includes (Fig. 63):
> Graphics TMT1 and ON (or OFF) flashing.
> Set Point (Transmitter's Serial Number (Link Code)).
 Pressing and releasing the S button momentarily (< 2
seconds) will toggle between ON and OFF.
 Pressing and releasing the A button momentarily (< 2
seconds) will accept the ON/OFF selection.
 If OFF is selected, S T TMT 2 and TMT 3 will be bypassed
and the operation reverts to the S T U screen.
 If ON is selected, the first (left) digit of the Code will flash.
 Pressing and releasing the S button momentarily and
repeatedly (< 2 seconds each time) will increase the First
Digit from 0 to 9 in increments of 1.
 Depressing and holding the S button will scroll through the
Set Points at a rate of 4 per second.
 Pressing and releasing the A button (< 2 seconds) will
accept the First Digit of the Code and/or advance to the
Second Digit which will be flashing.
 Pressing and releasing the S button shall increase the
Second Digit from 0 to 9 in increments of 1.
 Depressing and holding the S button will scroll through the
Set Points at a rate of 4 per second.
 Pressing and releasing the A button (< 2 seconds) will
accept the Second Digit of the Code and/or advance to the
Third Digit which will be flashing.