Aeris Epic Operating Manual page 18

18
To check the condition of the PIC or a Transmitter's Battery if
NORM or GAUG Mode is selected, depress the S button for 2
seconds while viewing the NORM, GAUG, or FR
Main Display, then release it.
 As the button is depressed, the ATOM's Receiver will
activate, if in NORM or GAUG Mode.
 2 seconds later, the PIC's Battery status will be displayed
for 3 seconds (Fig. 5), then -
 if active and linked, Transmitter 1's Battery status will be
displayed for 3 seconds (Fig. 6A), then -
 if active and linked, Transmitter 2's Battery status will be
displayed for 3 seconds, then -
 if active and linked, Transmitter 3's Battery status will be
displayed for 3 seconds, then -
 the display will then revert to Surface Mode.
 If a Transmitter is not active and linked, the message
NotAvAil (not available) will be displayed (Fig. 6B).
Tank Pressure (described later) will also appear on the active
Transmitters Battery Status displays.
NOTE: If Transmitter -3 Use is set for BUD
(Buddy Pressure Check), Battery Status of those
Transmitters is not displayed (only Pressure).
Surface