NEC Univerge SV8100 Features And Specifications Manual page 2062

Issue 11.0
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
For this feature...
Department Step
Calling
Direct Station
Selection /
One-Touch
Calling
Do Not Disturb
Do Not Disturb/
Call Forward
Override
General Purpose
Relay
Group Call Pickup
Handset Cutoff
Hotline
3 - 30
Table 3-4 Function Key Codes by Feature (Continued)
press the key and enter the code (e.g., 48 for Voice Over).
Use this key...
Code: 36
Operation: Dial busy
ext + Press key
Code: 01
Operation: Press key
+ dest. ext. or outside
tel. # + Hold
Code: 03
Operation: Press key
+ code (0~4)
Code: 37
Operation: Press key
Code: 51 + relay
number
Operation: Press key
Code: 24
Operation: Speaker
key +
Press key
Code: 25
Operation: Speaker
key +
Press key
Code: 26 + Pickup
Group (1~8 or 1~9 or
01~64)
Operation: Speaker
key + Press key +
Pkup Group
Code: 40
Operation: Press key
Code: 01 + dest. ext
Operation: Press key
When you ...
Step Call through a
Department Group for an
idle member.
Call an extension or
outside number using a
DSS key.
Set your telephone in
DND.
Call an extension which is
in DND or Call Forwarded.
Activate the general
purpose relay.
Answer a call ringing
another telephone in your
Pickup Group.
Answer a call ringing a
telephone in another
Pickup Group – if you do
not know the group
number.
Answer a call ringing a
telephone in a specific
Pickup Group.
Cut off the handset
transmission while on a
call.
Place a call to your Hotline
partner.
UNIVERGE SV8100
Also See
Key Lamp Status
Srvc Code
None
Off = extension
idle
On = extension
busy
Flashing = DND
DND key on red
None
On when active
None
None
None
On when feature
active (no
transmission on
handset)
Full BLF (red) for
covered ext.
Codes Tables
2
-
747
-
780
#

769
768
-
-