Caller Id Display After A Call Transfer; Figure 2-66 Ip Dect - Caller Id Display - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

With SV8100 Version 5000 (5.00 or higher) software and PZ-IPLB daughter board

installed, half duplex connections are not supported. For troubleshooting purposes, a

managed switch capable of port mirroring is required to capture packet data from the

SV8100 IPLB Ethernet port.

Caller ID Display After a Call Transfer

Previously in case of screened transfer, if a call was from a trunk line or legacy terminal, etc, the

transferrer's calling party number was displayed in IP DECT. In case of an unscreened transfer, the

calling party number from where the call was transferred is displayed on the IP DECT.

This feature enables the IP DECT terminal to display the calling party number of the original caller

(Transferee) when making a screened or unscreened transfer to an IP DECT terminal.

Calling party name is not supported in this feature.

In case of a screened transfer, when the transfer is made, IP DECT shows the calling party

number of the original caller (Transferee) after answering the call.

In case of an unscreened transfer, when the transfer is made, IP DECT shows the calling

party number of the original caller (Transferee) before (and after) answering the call.

Wireless DECT (SIP)

Figure 2-66 IP DECT – Caller ID Display

Table of Contents