Designing Audio Behaviors - Polycom V500 System Administrator's Manual

Designing Audio Behaviors

4. Follow the steps in the Setup Wizard to finish installing the application
on the computer.
Anyone using that computer can then double-click on the
People+Content IP icon to present content during video conferences using
the V500 system.
You can make the application available to all users in your organization by
downloading the setup.exe file to a local location that everyone can access.
This section describes how to configure the audio behaviors of the
V500 system.
To configure general audio settings:
1. Go to System > Admin Settings > Audio.
2. Configure these settings:
Setting
Master Audio
Volume
Sound Effects
Volume
Incoming Video
Call
User Alert Tones
Bass
Treble
Mute Auto-Answer
Calls
Enable Internal
Ringer
Description
Sets the volume level for audio from the far site.
Sets the volume level of the ring tone and user alert tones.
Specifies the ring tone used for incoming calls.
Specifies the tone used for user alerts.
Sets the volume level for the lower frequencies without
changing the master audio volume.
Sets the volume level for the higher frequencies without
changing the master audio volume.
Specifies whether to mute incoming calls.
Incoming calls are muted by default until you press the
Mute button on the remote control.
Specifies an additional ring tone when receiving an
incoming call. The internal ringer is built into the system and
alerts you to incoming calls.
Customizing the V500 System
4 - 7