Enabling Aes Encryption - Polycom V500 System Administrator's Manual

Administrator's Guide for the V500 System

Enabling AES Encryption

4 - 12
3. Select and configure these settings:
Setting
Enable Remote
Access
Web Access Port
Allow Video
Display on Web
AES encryption is a standard feature on every V500 system. When it is
enabled, the system automatically encrypts calls to other systems that have
AES enabled.
To enable AES encryption:
Go to System > Admin Settings > General Settings > Security and select
AES Encryption.
Description
Specifies whether to allow remote access to the system by:
• FTP
• Web
• Telnet
• SNMP
You may select any of these, or any combination of them.
Note: The system restarts if you change the remote access
settings. This setting does not deactivate the associated
port, only the application. Use Web Access Port to disable
the port.
Specifies the port to use when accessing the system using
the V500 web interface.
If you change this from the default (port 80), specify a port
number of 1025 or higher, and make sure the port is not
already in use. You will need to include the port number with
the IP address when you use V500 web interface to access
the system. This makes unauthorized access more difficult.
Note: The system restarts if you change the web access
port.
Specifies whether to allow viewing of the room where the
system is located, or video of calls in which the system
participates, using the V500 web interface.
Note: This feature activates both near site and far site video
displays in Web Director.