Designing Audio Behaviors; Configuring General Audio Settings - Polycom VSX Series Administrator's Manual

Administrator's Guide for the VSX Series

Designing Audio Behaviors

Configuring General Audio Settings

4 - 20
This section describes how to configure the audio behavior of a VSX system,
including:
• General audio settings
• Settings for Polycom StereoSurround
• Settings for the Polycom Vortex mixer
• Settings for microphones connected directly to the balanced audio inputs
The Audio Settings screens let you specify the settings appropriate for the
equipment you are using.
To configure general audio settings:
1. Go to System > Admin Settings >Audio > Audio Settings.
The Audio screen, where you choose Audio Settings or Stereo Settings, is
not present on a VSX 3000 or VSX 3000A. It is available on a set-top or
component system after you have enabled the Polycom StereoSurround
option.
2. Configure these settings:
Setting
Sound Effects
Volume
Incoming Video
Call
User Alert Tones
Mute Auto-Answer
Calls
Enable Internal
Ringer
VSX 3000
VSX 3000A
Description
Sets the volume level of the ring tone and user alert tones.
Specifies the ring tone used for incoming calls.
Specifies the tone used for user alerts.
Specifies whether to mute incoming calls.
Incoming calls are muted by default until you press the mute
on the microphone or on the remote control.
Specifies an additional ring tone when receiving an
incoming call. The internal ringer is built into the system and
alerts you to incoming calls.