Replacing A System Fan - IBM 9006-22P Servicing
Hide thumbs
Also See for 9006-22P:
- Installing and configuring (148 pages) ,
- Problem analysis, system parts, and locations (134 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
Figure 31. Removing a fan
Replacing a system fan in the 9006-22P
To replace the fans in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Lower the fan into the system and align the fan with the slots in the fan holder as shown in Figure 32
on page 37. Press the fan down until it snaps into place.
36 Power Systems: Servicing the 9006-22P
Advertisement
Table of Contents
