Table of Contents
Advertisement
Setting the Overall Patch
Volume Level (V-BASS LEVEL)
You can set the overall patch volume level with the V-BASS LEVEL
knob. Soon after the knob is turned, the V-Bass settings value pops
up in the screen.
* You can also adjust this parameter in Page 2 of the Mixer screen.
fig.01-060d
Adjusting the Overall Patch Tone
(TOTAL EQ)
You can make separate settings in each individual patch for the
overall tone after sounds have passed through the mixer.
1.
Press [MIXER].
2.
Press PAGE [
] [
3.
Switch the EQ on or off with [F1] (ON/OFF) on
Page 3.
4.
Set the tonal quality with [F1]–[F6] or with the
F1–F6 knobs.
5.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If not saving the settings, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
"TOTAL EQ (Total Equalizer)" (p. 131).
] to display Page 3 or 4.
Chapter 2 Creating Sounds
Setting the Output Signal and
Level (OUTPUT)
This sets the signals and levels output for each of the VB-99's output
jacks and connectors.
1.
Press [MIXER].
2.
Press PAGE [
] to display Page 5.
3.
Set the signal and level output to MAIN OUT
and SUB OUT with [F2]–[F5] or with the F2–F5
knobs.
For detailed information on the parameters that can be
set, refer to "OUTPUT" (p. 132).
4.
Press PAGE [
] to display Page 6.
5.
Set the signal and level output to DIGITAL OUT
with [F2], [F3] or with the F2, F3 knobs.
6.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If not saving the settings, press [EXIT] to return to the Play screen.
You can also set the output signal and level for the
entire system.
1.
Press [SYSTEM].
2.
Press PAGE [
] [
3.
Press [F1] (OUTPUT).
4.
Set the OUTPUT MODE parameter to
SYSTEM with [F1] (SELECT) or the F1
knob.
The value in the MIXER screen is disregarded, and
instead the SYSTEM value < > is applied.
] to display Page 2.
33
Advertisement
Table of Contents
