4A-14 HYDRAULIC BRAKES
LCRV SETTING METHOD
1. LCRV setting should be performed with unladen vehicle
condition.
2. Install the connecting rod (a) to the No.1 hole.
Tightening Torque
3. Adjust the clearance "X" to be 0 mm and tighten the bolt (c)
using the lock nut (b).
Tightening Torque
4. Remove the connecting rod (a) from the No.1 hole and
reinstall it to the No. 2 hole.
5. Place alignment marks between the lock nut (b) and
adjusting screw (c) after the valve setting.
14 - 18 Nm
14 - 18 Nm