Daewoo MUSSO Service Manual page 1197

Assembly Procedure
General Information
1. Use special tools during assembly of oil seals and bearings.
2. Lubricate bearings, oil seals and bushings before assembly.
Transfer Case
1. If the ring gear was removed, align the outer diameter of
the new replaced ring gear with transfer case and assemble
it.
2. Insert the pin.
3. Insert the ball bearing to the case and install the retaining
ring.
4. Install the new oil seal by pressing into the case.
5. Make sure that all parts are correctly and firmly installed
into the case.
Electric Shift Cam Parts
1. Insert the spacer into torsion spring.
2. Insert the end of the shift shaft into the spacer smoothly.
TRANSFER CASE (PART TIME 4408) 5D1-25
105 Case Assembly
106 Oil Seal
107 Retaining Ring
108 Ball Bearing
109 Pin
110 Ring Gear
111 Case
106 Oil Seal
109 Pin
110 Ring Gear
111 Case
100 Electric Shift Cam
101 Torsion Spring
102 Spacer
103 Shift Shaft