Daewoo MUSSO Service Manual page 969

4F-20 ANTILOCK BRAKE SYSTEM
Removal & Installation Procedure
ABS Hydraulic Unit
1. Release the ABS wiring connector locking lever in arrow
direction and remove the connector.
Notice
Do not force the connector when releasing in arrow
direction.
For installation of the connetor, align and firmly seat
the connector of the hydraulic unit and wiring connector
while keeping the locking lever upward and then push it
down.
2. Remove the hydraulic lines of the hydraulic unit.
During removal, be careful not to drip brake fuid on the
body.
Installation Notice
Tightening Torque
3. Unscrew hydraulic unit mounting nuts (2EA) and remove
the unit from the bracket.
Installation Notice
Tightening Torque
Notice
When carrying a new unit, never recline it over 30°.
Removal of the ABS / ABD Unit
Location : Under the front passenger's seat.
1. Remove the wiring connector of the ABS/ABD(or
ABS:attached type) ECU.
2. Remove the ground wire.
3. Unscrew the mounting bolts and remove the ECU.
4. Installation should follow the removal precedure in reverse
order.
12 - 16 Nm
9 - 12 Nm