Daewoo MUSSO Service Manual page 885

Removal & Installation Procedure
1. Remove the propeller shaft from the front axle input shaft.
Notice
Before removal, place the alignment marks.
Installation Notice
Tightening Torque
2. Remove the breather hose.
3. Remove the axle housing mounting nuts (1) from the cross
member.
Installation Notice
Tightening Torque
4. Remove the cross member mounting nuts (2) from the frame
and remove the cross member.
Installation Notice
Tightening Torque
5. Support the axle housing on a suitable jack, Remove the
axle housing mounting bracket nuts.
Installation Notice
Tightening Torque
6. Lowering the jack carefully, remove the axle housing
assembly.
7. Installation should follow the removal precedure in the
reverse order.
70 - 80 Nm
95 - 142 Nm
62 - 93 Nm
95 - 142 Nm
FRONT DRIVE AXLE 3A-15