Daewoo MUSSO Service Manual page 1053

5A-74 AUTOMATIC TRANSMISSION
Table 6.2.4 - After Teardown Faults
Symptom
C2 burnt
T-bar linkage out of adjustment.
56 foiled - stuck low.
Overdrive/output shaft sealing rings damaged.
C2 piston cracked.
C4 burnt
Incorrect C4 pack clearance.
C4 wave plate broken.
C4 wave plate not lined up properly.
Overdrive or output shaft sealing rings dam-
aged.
3-4 one way clutch (OWC) in backwards.
C2 piston cracked.
Over-run clutch (OC)/low-1st ball misplaced.
B1 burnt
B1R spring broken.
Input shaft sealing ring cut.
C1/B1R ball misplaced.
C1 burnt
B1R spring left out.
Overdrive or input shaft sealing rings damaged.
C1 piston cracked.
Ball capsule jammed.
4-3 sequence valve in backwards.
Clutch apply feed (CAF)/B1R ball left out.
Slips in reverse -
Rear band incorrectly adjusted or damaged.
no manual 1st
Reverse-low/first ball misplaced.
Firm converter
Input shaft 'O' ring missing or damaged.
lock or unlock
Converter clutch regulator valve in backwards.
No lock up at light
Input shaft 'O' ring missing or damaged.
throttle
C1 bias valve in backwards.
Possible Cause Action
Inspect, repair C2 and adjust the linkage as neces-
sary.
Repair C2. Inspect, repair or replace S6 as neces-
sary.
Repair C2. Inspect, replace the sealing rings and/
or shaft as necessary.
Repair C2. Inspect, repair or replace the C2 piston
as necessary.
Inspect C4 and repair as necessary.
Inspect and adjust the C4 pack clearance as nec-
essary.
Repair C4. Inspect and replace the wave plate as
necessary.
Repair C4. Inspect and realign the wave plate as
necessary.
Repair C4. Inspect and realign the sealing rings
and/or shaft as necessary.
Repair C4. Inspect and refit the OWC as neces-
sary.
Repair C4. Inspect and replace the C2 piston as
necessary.
Repair C4. Inspect and refit the ball as necessary.
Inspect and repair B1 and replace the spring as
necessary.
Replace sealing ring.
Repair B1. Refit the ball as necessary.
Inspect and repair C1 and replace the spring.
Repair C1. Inspect and replace the sealing tongs
and/or shaft as necessary.
Repair C1. Inspect and replace the C1 piston as
necessary.
Repair C1. Inspect and refit the capsule as neces-
sary.
Repair C1. Inspect and refit the valve as neces-
sary.
Repair C1. Inspect and replace the ball as neces-
sary.
Inspect and adjust the band as necessary.
Inspect and refit the ball as necessary.
Inspect and replace the 'O' ring as necessary.
Inspect and refit the valve as necessary.
Inspect and replace the 'O' ring as necessary.
Inspect and refit the valve as necessary.