Daewoo MUSSO Service Manual page 778

Removal Procedure
1. Position then no.1 cylinder at 15° ATDC.
Notice
Do not rotate the engine in opposition direction of engine
rotation.
2. Remove the connecting rod (9).
3. Disconnect the vacuum lines (13, 14).
4. Remove the accelerator control damper (10).
(Manual transmission vehicle)
5. Remove the suction line (16) and pressure line (4).
6. Remove the banjo bolt (1) and then remove the seal (2)
and fuel line (3).
7. Remove the plastic clip (8) on the injection line.
8. Disconnect the injection lines (15) from the injection pump
(25).
9. Remove the banjo bolt (1) and then remove the seal (7)
and return line (5).
OM600 ENGINE CONTROLS 1F3-47