Daewoo MUSSO Service Manual page 1398

9L-6 GLASS AND MIRRORS
4. Installation of glass dam rubber.
Using a double - faced adhesive tape, install the dam
rubber keeping 10mm from the edge of glass. If intervals
are irregular, primers and sealants can be applied
unevenly.
If need to remove the improper dam rubber, do not
remain the double - faced adhesive tape on the glass.
Improperly installed tape causes the inferior appearance
and weakening of adhesive strength of sealant.
5. Apply glass primer to the outer area of the dam rubber.
Notice
Do not apply body primer to the glass.
Do not touch the primer applied surface. If you touch,
this may cause water leakage after installation of the
windshield.
Keep water or dust away from the primer applied surface.
6. Apply sealant to windshield glass.
Uneven application of sealant may cause water leakage
after installation of the glass.
Do not touch the glass moldings and dam rubber while
applying sealant.
Turn over the glass and apply sealant.
7. Using suction holders, install the windshield within 5minutes
after application of sealant.