Daewoo MUSSO Service Manual page 1201

Front Output Shaft
1. Position the output shaft in transfer case and install the
companion flange assembly, oil seal, washer and nut.
2. Holding the companion flange, tighten the nut.
Reduction Shift Parts
1. Install the new pin, roller and retainer into the reduction
shift fork.
2. Press the pin, roller and retainer into the reduction spilt fork
bore completely.
Notice
Make sure that the cam roller turns freely.
3. Install the 2 fork facing on the reduction shift fork assembly.
4. Install the reduction shift fork onto the previously installed
reduction hub in the transfer case.
5. Install the output shaft spline into the reduction hub and
engage the output shaft end with input shaft bearing.
Notice
For installation of the output shaft, assemble
the oil pump temporarily.
65 Nut
66 Washer
67 Oil Seal
70 Companion Flange
71 Output Shaft (Front)
111 Case
TRANSFER CASE (PART TIME 4408) 5D1-29
55 Output Shaft
57 Reduction Hub
58 Shift Fork Facing
59 Reduction Shift Fork Assembly
60 Roller, Pin and Retainer Assembly
61 Retainer
62 Pin
63 Roller Cam
64 Reduction Shift Fork