1G1-6 M162 ENGINE INTAKE & EXHAUST
Removal & Installation Procedure
Upper Intake Manifold
1. Disconnect the vacuum hose (8,9).
2. Loosen the clip (22).
3. Remove the upper intake manifold (5) after unscrewing the
bolt (6).
Installation Notice
Tightening Torque
Notice
Check the gasket and replace it if necessary.
4. Installation should follow the removal procedure in the
reverse order.
Lower Intake Manifold
Preceding work : removal of upper intake manifold
1. Remove the hose of brake booster vacuum line and idle
speed connector.
2. Disconnect the hot water inlet pipe from the bottom of lower
intake manifold.
3. Unscrew the bolt (17) and remove the lower intake manifold
(16).
Installation Notice
Tightening Torque
4. Start the engine and check for leaks at each connection
part.
22.5 - 27.5 Nm
22.5 - 27.5 Nm