Daewoo MUSSO Service Manual page 762

Tools Required
601 589 00 08 00 Flange
601 589 05 21 00 Locking Screw
116 589 20 33 00 Sliding Hammer
116 589 02 34 00 Threaded Bolt
667 589 04 63 00 Retaining Plate
Removal & Installation Procedure
1. Remove the bolts (2) and then remove the cylinder head
cover (1) and gasket (3).
Installation Notice
Tightening Torque
Notice
Replace the gasket.
Rotate the engine 1 revolution by hand and check TDC
marking of the crankshaft and camshaft.
2. Loosen the camshaft sprocket bolt (14).
Notice
Do not remove the bolt.
Installation Notice
Tightening Torque
Notice
If max. length of bolt exceeds 53.6mm, replace it.
3. Loosen the bolt (11) (left-hand thread).
Notice
Do not remove the bolt.
10 Nm
25Nm + 90°
OM600 ENGINE CONTROLS 1F3-31