Daewoo MUSSO Service Manual page 1270

6A-8 POWER STEERING SYSTEM
Removal & Installation Procedure
1. Remove the cotter pin and nut and separate the steering
gear box tie rod from the steering knuckle arm using the
puller.
Installation Notice
Tightening Torque
2. Remove the bolt and separate the lower sha from the
steering gear box.
Installation Notice
Tightening Torque
Tighten the bolt toward threadless side of lower shaft
coupling.
3. Remove the oil pipe from the steering gear box and drain
the oil.
Installation Notice
Tightening Torque
4. Remove the clamp bolts and remove the steering gear box
assembly.
Installation Notice
Tightening Torque
Notice
Be careful not to damage the rubber(1).
When installing tighten the bolt (3) with the rubber
(2)being inserted to the hole of clamp.
5. Bleed the air from system.
6. Check the toe-in.
35 - 45 Nm
30 - 40 Nm
12 - 18 Nm
70 - 90 Nm