Daewoo MUSSO Service Manual page 1040

Identification
Pin
No.
Mode Indicator Lamp -
9
'Power '
Throttle Position Sensor
10
Output as Pulse Width
Modulation for TOD
11 Air Conditioner Input Signal
12 Kickdown Switch
13 Mode Switch
Transfer Case Input
14
(High) -4WD Lamp High
15 Ignition Switch
16 Do not use
17 Gear Position '1' Lamp/
Gear Position Code 1
18 *Gear Position '2' Lamp/
Gear Position Code 2*
Gear Position '3' Lamp/
19
Gear Position Code 3*
20 Gear Position 'Drive'
Lamp/
Gear Position Code 4*
21 CAN (-ve)
22 CAN (+ve)
23 K-line Communication Link
24 Engine Speed Input
Sensor (+ve)
25 Road Speed Pulses
26 Shaft Speed Sensor
Signal
27 Throttle Position Sensor -
Ground
28 Throttle Position Sensor -
Reference
29 Throttle Position Sensor -
Input Signal
30 Transfer(or Case Input
(Low) - 4WD Lamp Low
4WD
Type 4WD
(Gas)
(Diesel)
OP
OP O
O
- O
IP
IP
IP
IP
-
O
O
OP
OP
OP
OP
I/O
O
I/O
O
I/O
IP
O
OP
IP O
GND O
REF O
IP O
IP
AUTOMATIC TRANSMISSION 5A-61
Description
Indicates 'POWER' mode shift schedule is se-
lected.
Provides an analogue signal of the throttle po-
sition for the Torque on Demand (TOD) Con-
trol Module.
Input
Switch to indicate when a kickdown is required
at high throttle position.
Switch to select 'NORMAL', 'POWER' or 'WIN-
TER' shift schedule.
Voltage varies from OV to 12V.
Switch to indicate 4WD'HIGH RANGE' is se-
lected.
Ignition power is used as the main power source
to drive the unit and the solenoids.
Drives jewel in the instrument cluster to indi-
cate
gear leverposition'1'. Drives jewel in the instru-
ment cluster to indicate
gear lever position'2'. Drives jewel in the instru-
ment cluster to indicate gear lever position'3'.
Drives jewel in the instrument cluster to indi-
cate
'DRIVE'. gear lever position.
CAN low side bus communication (CANL).
CAN high side bus communication (CANH).
Diagnostic information and vehicle coding.
Flywheel/Ring gear pulses to indicate engine
speed.
Road speed signals derived from shaft speed
sensors.
This sensor transmit shaft speed signal to the
TCU.
Throttle position sensor ground.
This is the 5V reference voltage supply gener-
ated by the unit for the throttle position sensor.
This sensor is a resistance potentiometer indi-
cating throttle position.
Voltage varies 0V to 5V.
Switch to indicate 4WD'LOW RANGE' is se-
lected.