Daewoo MUSSO Service Manual page 1106

Torque Converter and Housing Assembly
To assemble the torque converter and housing assembly,
proceed as follows.
1. Locate the torque converter housing on the transmission
main case.
2. Install and tighten the securing bolts to specification.
Notice
All the hardware must be correctly installed and torqued to
specification.
3. Fit the converter ensuring that the tangs are engaged in
the pump gear. Ensure that the tangs do not contact the
pump seal.
Figure 8.1 - Torque Specifications
Torque converter housing to case
Extension housing to case
Rear servo cover
Pan to case
Inhibitor switch to case
Cooler connectors
Transmission filler plug
Output flange lock nut (RWD models)
Centre support to case
Cam plate to case (parking pawl)
Valve body to case
Upper valve body to lower valve body
ON/OFF solenoid retainers
Variable pressure solenoid retainer
Line pressure plug
Detent spring
Pump cover to case
Pump cover plate to pump cover
Pump to pump adaptor
Pump cover plate to crescent
Adaptor to case
Torque Specifications
AUTOMATIC TRANSMISSION 5A-127
N m
54 - 68
54 - 68
25 - 35
4 - 6
2.3 - 3.4
30 - 35
30 - 35
100 - 110
20 - 27
16 - 22
8 - 13
11 - 16
8 - 12
8 - 12
4 - 7
20 - 22
24 - 34
13 - 16
24 - 27
13 - 16
25 - 35