Table of Contents
Advertisement
14. Using a needle nose pliers, install the reverse fork spring
to its pin inside the case. Check the operation of the 5-R
shift mechanism at this time.
15. Using a snap ring piers, install the slip yoke snap ring onto
the end of the main shaft.
16. Make sure that the 1-2 and 3-4 synchronizer sleeves and
5-R shift lever are in neutral position.
17. Align the holes the case and cover with alignment-type
bolts. Tighten the 10 bolts.
18. Apply 'RTV' sealant on the sealing surface of the extension
housing.
19. Apply grease on the detent/guide plate in the extension
housing. Install the detent ball in the 3-4 position.
20. Place the detent spring and offset lever in the extension
housing and push the extension against the case and shift
cover.
MANUAL TRANSMISSION 5B-25
Advertisement
Chapters
Table of Contents
