Daewoo MUSSO Service Manual page 801

1G2-8 M161 ENGINE INTAKE & EXHAUST
Removal & Installation Procedure
1. Disconnect the battery ground cable.
2. Remove idle speed control plug connector (arrow).
3. Disconnect the brake booster vacuum line and other
vacuum lines.
4. Disconnector the rod from bearing bracket assembly and
remove the connection piece (8).
Installation Notice
Tightening Torque
5. Unscrew the three bolts (4) and remove the idle regulator
and intermediate flange (6).
Installation Notice
Tightening Torque
6. Unscrew the two bolts (M8 X 16) and remove the support
assembly (arrow).
Installation Notice
Tightening Torque
7. Unscrew the intake manifold assembly mounting bolts (1)
and remove the intake manifold and gasket.
Installation Notice
Tightening Torque
Notice
Replace the gasket with new one.
8. Installation should follow the removal procedure in the
reverse order.
9. Start the engine and check for leaks in each connection.
36 - 44 Nm
22.5 - 27.5 Nm
22.5 - 27.5 Nm
22.5 - 27.5 Nm