Daewoo MUSSO Service Manual page 1081

5A-102 AUTOMATIC TRANSMISSION
Front Band Assembly
To assemble the front band assembly, proceed as follows.
1. Install the reaction anchor strut to the case.
2. Check the band for ally cracks or damage along its lining
and metal backing.
3. Position the strut retainers on the band (refer to figure
8.23).
NOTICE
If fitting a new band, soak the band in automatic
transmission fluid for a minimum of 5 minutes prior to
assembly.
4. Install the front band into the transmission case, ensuring
that it is properly seated in place.
5. Position the reaction strut in its retaining clip and engage
it with the band and anchor strut.
Position the apply strut in its retaining clip and engage it
with the band and the servo piston rod.
C2/C4 Clutch Assembly
Notice
1. Check pistons for cracks.
2. Do not mix the clutch piston return springs.
3. Ensure that the snap rings are fitted correctly.
To assemble the C2/C4 clutch assembly (refer to figure 8.24),
proceed as follows.
1. Check the feed orifices in the cylinder bore are clear of
obstructions.
2. Check the C2 piston bleed orifices are clear of obstructions.
3. Lubricate the 'O' rings with automatic transmission fluid.
Notice
'O' rings must not be twisted in the grooves.
4. Fit the small 'O' ring onto the inner groove, and the large
'O' ring onto the outer groove of the piston.
5. Check the C4 piston bleed orifices are clear of obstructions.
6. Lubricate the 'O' rings with automatic transmission fluid.
7. Fit the small 'O' rings onto the inner groove and the large
'O' rings onto the outer groove of the piston.
8. Position the clutch cylinder with the C2/C4 cavity facing
upwards.
9. Fit the C4 piston into the C2 piston with the bleed orifices
in alignment.
10. Install the C2/C4 piston assembly into the cylinder, with the
piston bleed orifices aligned with the holes on the outside
of the cylinder, until the outer diameter of the C2 piston
enters the inner diameter of the cylinder.
Figure 8.23 - Front Band Strut Installation
Figure 8.24 - Typical C2/C4 Clutch Assembly