Daewoo MUSSO Service Manual page 1062

7. Remove the rear propeller shaft.
Installation Notice
Tightening Torque
8. Unscrew the five bolts and remove the transfer case.
9. Disconnect the 10-Pins Plug connector from transmission.
10. Separate the locking clip on shift lever and remove the
shift rod.
Notice
Removal and installation performed when the shift
procedure should be lever is in "D" range.
11. Remove the two pipes for oil cooler.
Installation Notice
Tightening Torque
12. Remove the service hall cover on torque converter.
13. Put the alignment mark for installation, and unscrew the
six mounting bolts for torque converter from drive plate
through the service hole (arrow) by rotating the engine
and remove the torque converter.
Installation Notice
Tightening Torque
Screw the six bolts mounting the torque converter through
the service hole by using a mirror and rotating the engine.
70 - 80 Nm
24.5 - 34.3 Nm
42 Nm
AUTOMATIC TRANSMISSION 5A-83