Daewoo MUSSO Service Manual page 396

1B3-92 OM600 ENGINE MECHANICAL
24. Insert the new connecting rod bearing shells into the
connecting rod and connecting rod bearing cap and tighten
the 12-sided stretch bolts (11).
Tightening Torque
25. Measure inner diameter of connecting rod bearing.
26. Measure connecting rod bearing journal diameter (K).
Notice
Refer to measurement of the crankshaft bearing journal
diameter.
27. Measure the radial clearance (L) of the connecting rod
bearing.
Example) Measured value 'J' = 47.700mm
Measured value 'K' = 47.653mm
Clearance 'L'
Radial Clearance 'L'
Notice
If the clearance is out of standard, adjust the radial
clearance of connecting rod bearing by replacing the
connecting rod bearing shells.
28. Remove the connecting rod bearing cap.
29. Install the piston.
30. Rotate the crankshaft by hand and check whether it rotates
smoothly.
31. If the bearings are damaged,
- replace the oil presser relief valve.
- clean the oil pump and oil filter housing carefully and
replace the hose if necessary.
Notice
After assembling the engine, check the camshaft timing,
adjust the start of fuel injection and check the TDC sensor
bracket setting.
32. Fill oil and run the engine and then check the oil pressure
and oil level.
Notice
Install the original oil filter element and then change the
engine oil and oil filter element after 1,000 - 1,500km.
40 Nm + 90°
= 0.047mm
0.026 - 0.068mm