Daewoo MUSSO Service Manual page 411

Tools Required
102 589 03 40 00 Magnetic Bar
116 589 06 63 00 Magnetic Finger
601 589 01 59 00 Assembling Board
601 589 02 59 00 Supporting Bridge
667 589 00 31 00 Press Lever
Removal & Installation Procedure
1. Remove the nuts (8) uniformly and then remove the washer
(7), exhaust manifold (9) and gasket.
Installation Notice
Check the stud bolt (6) for damage and replace if necessary.
Tighten Torque
Replace the gasket and tighten the nuts (8).
Tighten Torque
2. Install the assembling board (11) to the cylinder head with 4
cylinder head blots (10).
3. Pull out the valve tappet (1) with magnetic bar (12).
Notice
Place the valve tappets upside down (open end upward).
4. Install the supporting bridge (13) on the cylinder head (5).
12 Nm
25 Nm
Assembling Board 601 589 01 59 00
Magnetic Bar 102 589 03 40 00
Supporting Bridge 601 589 02 59 00
OM600 ENGINE MECHANICAL 1B3-107