Table of Contents
Advertisement
04/02 Rev. 2.15-01
Status Printout
Access to status
printout
Abortion
Sensor Check Routine
Green
Red
Orange
TTX 207 – Da Capo
Status printout for indication of internal data and print test. Please use mate-
rial with width of appr. 100 mm width.
Press and keep pressed ON/OFF key for 3 seconds.Simultaneously switch
the unit on.The green LED becomes illuminated, the print starts.
Press ON/OFF key until print stops.
Access to routine
Press and keep press CUT key for 3 seconds. Simultaneously switch the unit
on. The function is indicated by means of the LED's. The sensors/switch can
be selected by pressing the corresponding keys.
Gap sensor
Press ON/OFF key
Air or very opac backing paper is measured.
Backing paper or thin paper is measured.
Cardboard etc is measured.
Micro switch/printhead lever
Press FEED key
Green or orange are illuminated when opening or closing the lever.
Material end sensor
Press CUT key
With material the orange LED glows, without material the green one.
MANUAL
Setup, Operation, Service, page 13
Advertisement
Table of Contents
