Attaching The Anti Glare Ring; Adjusting The Camera Lens - Mobotix D71 Quick Installation Manual

NOTE! Electrical surge protection available using the MX-Overvoltage-Protection-Box, which is available as
an accessory.
Further information on how to avoid damage caused by lightning and over voltage is available from man-
ufacturers of lightning and over voltage protection devices.

Attaching the Anti Glare Ring

The anti-glare ring is used to protect the lens from glare effects that can have a negative effect on the camera
image.
CAUTION! The anti-glare ring is not mounted when delivered and should be installed before operating the
device.
1. Remove the dome (see
2. Remove the protective film from the adhesive surface of the anti-glare ring
3. Carefully press the anti-glare ring

Adjusting the Camera Lens

Adjusting the camera at the mounting position will ensure that you will see the desired field of view later on.
CAUTION! When adjusting the image focus or the field of view of the camera, always make sure that you
can see the live image of the camera on your monitor. See
Removing the Dome, p.
①
with the adhesive surface into the recess around the lens.
36)
Camera Software in the Browser, p.
Mounting

Adjusting the Camera Lens

1.14, p. 19 .
65.
35 / 72