Mounting To A Pole - Mobotix D12 Manuals

60
/124
Pole diameter can be 60
to 180 mm/2.4 to 7.1 in
D12 Camera Manual Part 1

2.11.2 Mounting to a Pole

Use the stainless steel straps supplied with the Corner and Pole Mount for affix-
ing the pole mount to a pole.
• Guide the stainless steel straps (item 27)
through the holes in the pole mount (see fig-
ure). Make sure that you are using the slots of
the mount which are fitting best for the thick-
ness of the pole. The stainless steel straps al-
low attaching the mount to poles with di-
ameters between 60 and 180 mm (2.4 to
7.1 in).
• Guide the camera cables from behind
through one of the large round holes of the
Corner and Pole Mount. In order to properly
protect the cabling, you should let the ca-
bling run from the inside of the pole through
the Corner and Pole Mount directly into the
camera.
Note: The cable to the camera should be
running at least 80 cm (32 in) outside of the
pole!
• Firmly tighten the screws of the stainless
steel straps. If required, clip the ends of the
stainless steel straps.
Next, mount the Outdoor Wall Mount to the Corner and Pole Mount, as de-
scribed in section 2.11.3, Mounting the Outdoor Wall Mount to the Corner and Pole
Mount .
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com