Adjust The Volume - CyberData 11304 Operation Manual

2.9.6.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To restore the factory default settings:
1. Press and hold the RTFM button (see
2. The device announces that it is restoring the factory default settings.
Note

2.9.7 Adjust the Volume

You can adjust the volume through the
Volume
Operations Guide
Each Intercom is delivered with factory set default values.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
settings on the Device Configuration
930947A
Figure 2-12) for more than five seconds.
Figure 2-12. RTFM Button
SIP Volume, Multicast
Page.
Installing the VoIP Emergency Intercom
Adjust the Volume
RTFM
Volume, Ring Volume, and
CyberData Corporation
18
Sensor