Adjusting The Intercom Volume; Adjust The Volume - CyberData 011414 Operation Manual

2.3.8.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To restore the factory default settings:
1. Press and hold the RTFM button (see SW1 in
2. The device announces that it is restoring the factory default settings.
Note

2.3.9 Adjusting the Intercom Volume

You can adjust the Intercom volume through the
Sensor Volume

2.3.10 Adjust the Volume

You can adjust the volume through the
Operations Guide
Each Intercom is delivered with factory set default values.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
settings on the Device
931338B
Installing the SIP-enabled h.264 Video Outdoor Intercom with Keypad
Figure 2-15) for more than five seconds.
Figure 2-15. RTFM Button
RTFM Button (SW1)
SIP Volume,
Page.
Device Page.
Intercom Setup
Multicast Volume, Ring Volume, and
CyberData Corporation
24