CyberData 11304 Operation Manual page 39

2. On the SIP Configuration page, enter values for the parameters indicated in
Web Page Item
Enable SIP Operation
SIP Settings
Primary SIP Server [registration status] Use this field to set the address (in dotted decimal notation or
Primary SIP User ID
Primary SIP Auth ID
Primary SIP Auth Password
Backup SIP Server 1
Backup SIP Server 2
Backup SIP User ID 1
Backup SIP User ID 2
Backup SIP Auth ID 1
Backup SIP Auth ID 2
Backup SIP Auth Password 1
Backup SIP Auth Password 2
Use Cisco SRST
Remote SIP Port
Local SIP Port
Outbound Proxy
Outbound Proxy Port
Register with a SIP Server
Re-registration Interval (in seconds)
Operations Guide
Table 2-9. SIP Configuration Parameters
Description
Enables or disables SIP operation.
as a canonical name) for the Primary SIP Server. This field can
accept canonical names of up to 255 characters in length.
Type the SIP User ID for the Primary SIP Server 
(up to 64 alphanumeric characters).
Type the Authenticate ID for the Primary SIP Server
(up to 64 alphanumeric characters).
Type the Authenticate Password for the Primary SIP Server
(up to 64 alphanumeric characters).
• If all of the Primary SIP Server and Backup SIP Server
fields are populated, the device will attempt to stay registered
with all three servers all of the time. You can leave the
Backup SIP Server 1 and Backup SIP Server 2 fields blank
if they are not needed.
• In the event of a registration failure on the Primary SIP
Server, the device will use the next highest priority server for
outbound calls (Backup SIP Server 1). If Backup SIP Server
1 fails, the device will use Backup SIP Server 2.
• If a higher priority SIP Server comes back online, the device
will switch back to this server.
Type the SIP User ID for the Backup SIP Server 
(up to 64 alphanumeric characters).
Type the SIP Authenticate ID for the Backup SIP Server 
(up to 64 alphanumeric characters).
Type the SIP Authenticate Password for the Backup SIP
Server (up to 64 alphanumeric characters).
When selected, the backup servers are handled according to
Cisco SRST (Survivable Remote Site Telephony).
Type the Remote SIP Port number (default 5060) 
(8 character limit).
Type the Local SIP Port number (default 5060) 
(8 character limit).
Type the Outbound Proxy as either a numeric IP address in
dotted decimal notation or the fully qualified host name 
(255 character limit [FQDN]).
Type the Outbound Proxy Port number (8 character limit).
Check this box to enable SIP Registration.
For information about Point-to-Point Configuration, see
2.10.6.2, "Point-to-Point
The SIP Registration lease time in seconds.
930947A
Installing the VoIP Emergency Intercom
Configure the SIP Parameters
Table
Configuration".
CyberData Corporation
32
2-9.
Section