Adjust The Volume - CyberData 011211x Operation Manual

Voip v3 indoor intercom
Table of Contents

Advertisement

2.3.5.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To restore the factory default settings:
1. Press and hold the RTFM button (see SW1 in
2. The device announces that it is restoring the factory default settings.
Note

2.3.6 Adjust the Volume

You can adjust the volume through the
Operations Guide
Each Intercom is delivered with factory set default values.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
930500I
Figure
2-10) for more than five seconds.
Figure 2-10. RTFM Button
Speaker Volume
setting on the
Installing the VoIP V3 Indoor Intercom
Adjust the Volume
Device Configuration
CyberData Corporation
16
Page.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 011211x and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents