CyberData 11304 Operation Manual page 34

Web Page Item
Activate Relay During Ring
Activate Relay During Night Ring
Activate Relay While Call Active
Activate Relay on Button Press
Relay on Button Press Timeout (in seconds) Type the desired time (in seconds) that you want the relay
Miscellaneous Settings
Auto-Answer Incoming Calls
Button Lit When Idle
Button Brightness (0-255)
Play Ringback Tone
Enable Push to Talk
Operations Guide
Table 2-7. Device Configuration Parameters (continued)
Description
When selected, the relay will be activated for as long as
the call is active.
NOTE: When the phone is set to Auto Answer, it will not
ring and this option does nothing.
Check this box to activate the relay for as long as a Night
Ring tone is ringing.
When selected, the relay will be activated for as long as
the call is active.
When selected, the relay will be activated when the Call
Button is pressed.
to activate after the Call Button is pressed (1 character
limit).
When selected, the device will automatically answer
incoming calls.
When Auto Answer is Off, the device will play a ringtone
through the Intercom speaker until someone presses the
button.
When selected, the Call Button remains lit when idle.
Type the desired Call Button LED brightness level (0-255).
When selected, you will hear a ringback tone while making
a call.
This option is for noisy environments. When enabled, the
microphone will be muted normally. When the button is
pressed and held, it will unmute the microphone and allow
the operator to send audio back.
NOTE: When Enable Push to Talk is enabled, you cannot
stop an active call with the call button. The device on the
other end will need to end the call.
NOTE: Enable Push to Talk will not work on some older
hardware.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Test Audio button to do an audio test. When
the Test Audio button is pressed, you will hear a voice
message for testing the device audio quality and volume.
Click on the Test Microphone button to do a microphone
test. When the Test Microphone button is pressed, the
following occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
930947A
Installing the VoIP Emergency Intercom
Configure the Device
CyberData Corporation
27