Restore The Factory Default Settings; Adjust The Volume - CyberData 011113 series Operation Manual

2.2.6.2 Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To set the factory default settings:
1. Press and hold the RTFM switch (SW1) for more than five seconds.
2. The speaker announces that it is restoring the factory default settings.
Note

2.2.7 Adjust the Volume

You can adjust the volume through the
Operations Guide
Each Intercom is delivered with factory set default values.
The speaker will use DHCP to obtain the new IP address (DHCP-assigned address or
default to 10.10.10.10 if a DHCP server is not present).
930323A
Installing the VoIP Indoor Intercom with Keypad
Figure 2-12. RTFM Switch
Device Configuration Page.
CyberData Corporation
15
Parts List
RTFM