Routing; Configure Ipv4 Static Routing - D-Link DWC-1000 User Manual

Section 5 - Advanced Network Configuration
A static route tells network devices about an exact, fixed (hard-coded) destination. Static routes can work well
with small networks. There are two kinds of static routing: Static Route and Protocol-Binding. The Static Route
uses IP address to determine the next hop, whereas Protocol-Binding use protocol. Configuring your wireless
controller for static routing allows data transfers between it and a routing device without using dynamic routing
protocols.
Path: Network > Routing > Static Routes
To add a static route:
1. Click Network > Routing > Static Routes.
2. Click Add New Static Route. The Static Route Configuration page will appear.
3. Complete the fields given in the table on the next page, and click Save.
D-Link DWC-1000 User Manual

Routing

Configure IPv4 Static Routing

177