Club Car Precedent 2004 Maintenance And Service page 65

STEERING AND FRONT SUSPENSION
Figure 7-14 Check Camber
Toe-in Adjustment
1. On a level surface, roll the vehicle forward, then stop. Make sure the front wheels are pointed straight
ahead. Do not turn the steering wheel again during this procedure.
2. On each front tire, mark (as closely as possible) the center of the tread face that is oriented toward the
rear of the vehicle. The marks should be even with the bottom surfaces of the vehicle frame.
3. Measure the distance between the marks on the rear-facing surfaces of the tires, and then roll the vehicle
forward one and one-half wheel revolution until the marks appear on the forward facing surfaces of the
tires at about the same height from the floor (Figure 7-16, Page 7-11).
Figure 7-16 Check Toe-In
4. Measure the distance between the marks on the forward-facing surfaces of the tires (Figure 7-16,
Page 7-11).
NOTE: The front measurement must be less than the rear measurement.
2004 Precedent IQ System Golf Car Maintenance and Service Manual
30
8
7
7 MM DEEP
WELL SOCKET
Figure 7-15 Adjust Camber
Figure 7-17 Adjust Toe-In
7
Front Suspension
Page 7-11