Club Car Precedent 2004 Maintenance And Service page 184

16A
TRANSAXLE (TYPE G)
Transaxle Disassembly and Inspection, Continued:
CAUTION
• Do not damage gears. Use extreme care when handling them.
5. Use a bearing puller or arbor press to remove bearings (16) from the input pinion gear. If the oil seal (10)
is damaged, replace it (Figure 16a-5, Page 16a-3). See also Figure 16a-13, Page 16a-8. See follow-
ing CAUTION.
CAUTION
• Do not reuse bearings after removing them. Replace bearings with new ones.
6. To disassemble the intermediate gear assembly, press off together the bearing (16) and the gear (19)
(Figure 16a-5, Page 16a-3). See also Figure 16a-13, Page 16a-8.
7. Press the bearing (18) off the intermediate gear assembly (Figure 16a-5, Page 16a-3).
Figure 16a-13 Intermediate Gear Assembly
8. Disassemble the differential gear case:
8.1. Remove four hex bolts (33) that secure the ring gear to the differential case (Figure 16a-5,
Page 16a-3).
8.2. Remove the ring gear. Retain dowel pin (34) from between the ring gear and differential case for
reassembly.
8.3. Separate the differential gear case housing. If necessary, install two of the hex bolts (removed pre-
viously in step 8.1.) into the differential gear unit and, while holding the unit slightly above the work
area, lightly tap the bolt heads (Figure 16a-14, Page 16a-9). Remove the two bolts.
Page 16a-8 2004 Precedent IQ System Golf Car Maintenance and Service Manual
PRESS RAM
ARBOR
Transaxle Disassembly, Inspection, and Assembly