Front Bumper - Club Car Precedent 2004 Maintenance And Service

BODY AND TRIM
Front Body Installation, Continued:
3. Install front beauty panel (3) over brow (5). Tabs on the forward edge of the front beauty panel should fit
into slots between the fascia and the brow.
4. Position brow cap (1) to cover the edge of both the brow (5) and the front beauty panel (3). Secure brow
cap (1) with four screws (2). Tighten screws to 3.3 ft-lb (4.5 N·m).

FRONT BUMPER

The underbody bracket (1) connects the front suspension to the front underbody (Figure 4-2, Page 4-5).
Each bracket is secured in place by two taptite screws (2) tightened to 13 ft-lb (17.6 N·m).
The front bumper (3) is attached to the vehicle frame rails by nuts (5) and bolts (4). The nuts (5) need to go on
top of the bumper attaching brackets, always insert the bolts (4) through the bottom. The nuts are tightened to
13.3 ft-lb (18 N·m).
2
1
2
3
4
UNDERBODY
FRONT
SUSPENSION
Figure 4-2 Bracket and Front Bumper
2004 Precedent IQ System Golf Car Maintenance and Service Manual
5
4
Front Bumper
Page 4-5